Linksys SRW2016 - Manual (Page 49)

39 Chapter 5: Using the Web-based Utility for Configuration
QoS Tab - Bandwidth
WebView Switches
QoS Tab - Bandwidth
Use the Bandwidth Settings page to define the bandwidth settings for specified ingress and egress interface.
Modifying queue scheduling affects the queue settings globally.
Port. Shows the port to which bandwidth settings are applied.
Ingress Rate Limit. Defines the ingress Rate Limit on the interface.
• Status. Indicates if rate limiting is enabled on the interface.
• Rate Limit. Configures the rate to which traffic is limited. The range is 70 - 285,000 kbps.
Egress Shaping Rates. Determines the Committed Information Rate (CIR) and Committed Burst Size (CBS) on the
interface.
• Status. Indicates if rate limiting is enabled on the interface.
• Committed Information Rate (CIR). Defines the CIR rate. The possible field range is 4096-1,000,000,000.
• Committed burst Size (CbS). Defines the CBS rate. The possible field range is 4096-16,000,000.
To modify the settings on this screen, click the Edit icon, which resembles a pencil, to open the edit screen.
Figure 5-29: QoS - Bandwidth
Figure 5-30: QoS - Edit Bandwidth
NOTE: On FE Switches, the bandwidth rate cannot be
limited if storm control is enabled.