Linksys SRW2016 - Manual (Page 39)

29 Chapter 5: Using the Web-based Utility for Configuration
Switch Conf. (Configuration) Tab - VLAN Interface Settings
WebView Switches
Switch Conf. (Configuration) Tab - VLAN Interface Settings
The VLAN Interface Settings screen lets you define properties of the interfaces that are associated with VLANs.
Interface. This is the physical address of the interface, Port or LAG.
Interface VLAN Mode. One of the following VLAN modes will appear
• General - The port belongs to VLANs, and each VLAN is user-defined as tagged or untagged (full 802.1q
mode).
• Access - The port belongs to a single, untagged VLAN. When a port is in Access mode, the packet tapes
accepted on the port cannot be designated. Ingress filtering cannot be enabled/disabled on an access
port.
• Trunk - The port belongs to VLANs in which all ports are tagged (except for one port that can be
untagged).
PVID. VLAN ID of untagged packets.
Frame Type. Packet type accepted on the port, Admit All (all packets are accepted) or VLAN Only (only VLAN
packets are accepted).
Ingress Filtering. Enables or disables Ingress filtering on the port. Ingress filtering discards packets that are
destined to VLANs of which the specific port is not a member.
To edit the interface settings for a particular VLAN, click the Edit icon, which resembles a pencil, for that
interface. On the screen that appears, you can settings for that interface. Click the Submit button when finished.
Figure 5-12: Switch Configuration - VLAN Interface Settings
Figure 5-13: Switch Configuration - edit VLAN Interface
Settings