Linksys SRW2016 - Manual (Page 103)

93 Chapter 5: Using the Web-based Utility for Configuration
Spanning Tree Tab on SRW2048 Switches - MSTP Instance Settings
WebView Switches
Spanning Tree Tab on SRW2048 Switches - MSTP Instance Settings
Use this screen to configure MSTP instances.
Instance ID. Defines the MSTP instance. The field range is 1-15.
Included VLANs. Displays VLANs mapped to the selected instance. Each VLAN belongs to one instance.
Bridge Priority. Specifies the selected spanning tree instance device priority. The field range is 0-61440 in steps
of 4096.
Designated Root Bridge ID. Indicates the ID of the bridge which is the root of the selected instance.
Root Port. Indicates the selected instance's root port.
Root Path Cost. Indicates the selected instance's path cost.
Bridge ID. Indicates the bridge ID of the selected instance.
Remaining Hops. Indicates the number of hops remaining to the next destination.
Click the Submit button to save any of your changes on this screen.
Clicking the VLAN Instance Configuration button opens the MSTP Instance Table, which shows how your VLANs
are assigned on the MSTP.
Figure 5-90: Spanning Tree - MSTP Instance Settings
NOTE: Rapid STP is available on the
SRW2048 Switches ONLY.