Lennox Hearth CANYON ST310 User Manual

Page 11

NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.

osT

nsTallaTion

hecks

1. Check that all chimney pipe joints are securely fas-

tened.

2. Check that the heater is securely fastened to the floor

(if applicable).

3. Make sure the intake vent has clear access to outside

air (if applicable).

4. Make sure the outside air vent has been sealed properly

to keep rodents out (if applicable).

5. Be sure all roof flashings are watertight.

6. Be sure the stove is properly grounded (if applicable).

FOR YOUR OWN PROTECTION AND INSURANCE PUR-

POSES, HAVE YOUR CHIMNEY AND CONNECTOR PIPE

INSTALLATION INSPECTED BY YOUR LOCAL BUILDING

CODE AUTHORITY OR FIRE MARSHAL BEFORE START-

ING A FIRE IN YOUR STOVE. NOTIFY YOUR INSURANCE

COMPANY.

rick

nsTallaTion

Caution: Wear gloves during brick installation in case

of sharp edges inside the stove.

Note: Installation of the baffle bricks and insulating blanket

is easier when you can still access the flue outlet, (before

connecting the flue pipe). Be sure the insulating blanket

is placed flat on the bricks so as not to block the flue. Use

a ruler or a piece of kindling to reach over the blanket to be

sure it is completely flat on top of the baffle bricks.

Measure bricks before installing, as per list of dimensions

on next page, to be sure the correct bricks are installed in

the correct location.

1. Install bricks #1-34 in the numbered sequence shown in

FIGURE 1 on the following page. (Note: Bricks # 22-25

lean up against the lower air channel and butt against

bricks #17-21 on the bottom of the stove.

Note: Before installing your baffle bricks make sure the

stainless steel tube support and front and rear tube

hangers are centered side to side and that the front

and rear hangers are hooked onto the stainless steel

pins protruding from the rear of the airwash and the

stove back.

2. Next install bricks #35-40 on top of the stainless steel

secondary burn tubes in the upper part of the firebox.

These bricks fit up against bricks #26-30 on the backwall

and should rest on the rear two stainless steel second-

ary tubes. Thes two sets of three bricks go either side

of the stainless steel secondary tube support running

front to rear down the center of the stove.

3. Be sure the stainless steel tube support is in the center,

as shown, and that its two stabilizer pieces in the front

and the rear are attached to the two hooks welded to

the firebox front and rear.

4. Included with the stove are two 13”x 17-1/2”x 1” thick

ceramic fiber blankets. Install a ceramic fiber blanket on

top of each set of three bricks, making sure the blankets

are pushed fully to the rear.

5. Next, install the front baffle bricks #41-46 under the

ceramic fiber blanket and on top of the front two stain-

less steel secondary tubes. (CAUTION: Make sure that

the ceramic fiber blankets are centered side to side and

rest flat on the baffle bricks and do not project forward

beyond the front of the baffle bricks #41-46).