Configuration menu overview 33 – Konica Minolta magicolor 2530 DL User Manual
Page 41
Configuration Menu Overview
33
FORCED
MODES
Settings
AUTO/AUTO/ON / AUTO/FULL/ON /
AUTO/HALF/ON / 100M/AUTO/ON /
100M/FULL/ON / 100M/FULL/OFF /
100M/HALF/ON / 100M/HALF/OFF /
10M/AUTO/ON / 10M/FULL/ON /
10M/FULL/OFF / 10M/HALF/ON /
10M/HALF/OFF
Some network hubs will not communicate with printers that
use a fixed network speed and structure. In such cases, use
the new
NETWORK/FORCED MODES
menu to configure the
printer for the appropriate hub settings and enable communi-
cation.
#
The first value indicates the network transmission speed
(
SPEED
). Select from a 10Base-T connection (
10M
),
100Base-TX connection (
100M
), or automatic recognition
(
AUTO
). If
AUTO
is selected, the transmission speed is set
depending on the negotiation; therefore, there is no setting
where negotiation is turned off.
#
The second value indicates the communication method for
bi-directional communication (
DUP
). Select whether data is
sent and received in both directions simultaneously (
FULL
)
or in one direction at a time (
HALF
), or select automatic
recognition (
AUTO
). If
AUTO
is selected, the transmission
speed is set depending on the negotiation; therefore, there
is no setting where negotiation is turned off.
#
The third value indicates the negotiation (
NEG.
) setting
(mutually sends and receives information such as the
transmission speed and determines the transmission set-
ting). When set to
ON
, negotiation is performed. When set
to
OFF
, negotiation is not performed.