Kenwood KDC-M7024 User Manual
Page 17
2
Remove the Backpanel forward.
When
DSI blinks.
• The back panel is a precision piece of equipment and can be
damaged by shocks or jolts. For that reason, keep the back panel
in its special storage case while detached.
• Do not expose the Backpanel or its storage case to direct sunlight
or excessive heat or humidity. Also avoid places with too much
dust or the possibility of water splashing.
Reattaching the Backpanel
1
Set the Backpanel to the panel bracket.
2
Hold down on the Backpanel until it is locked.
The Backpanel of the unit can be detached and taken with you,
helping to deter theft.
Removing the Backpanel
1
Turn the ignition OFF or press the [SRC] button for at least 1
second.
Turn OFF the power, and the control panel becomes horizontal.
After the set time passes in
panel is closed.
Theft Deterrent Panel
2
Enter Panel Position Setting mode
Press the [4] ("PNL") button.
3
Select the item for adjustment
Press the desired [2] — [5] button.
Each time the button is pressed the items that can be adjusted
switch as shown below.
Adjustment Item
Button
Display
The panel tilts upwards
[2]
"ANG–"
The panel tilts downwards
[3]
"ANG+"
The panel slides backward
[4]
"SLD–"
The panel slides forward
[5]
"SLD+"
4
Exit Panel Position Setting mode
Press the [RTN] button.
The control panel may be interfered with the shift lever or another
part depending on the angles of the control panel.
Set the angle to avoid any interference.
No sound is produced while the panel is operating.
— 17 —
KDC-M7024_U.S_r2 03.1.8 4:03 PM Page 17