Kenwood KDC-M7024 User Manual
Page 12
1st section
[2] button
Adjustment Item
Display
Range
Bass Center
Frequency
"Bass F"
60/70/80/100 or 150 Hz
Bass level
"Bass"
–8 — +8
Bass Q Factor
"Bass Q"
1.00/1.25/1.50/2.00
Bass Extend
"Bass EXT"
ON/OFF
5
Select the Audio Control item for adjustment
Press the [2] — [5] button.
Each time the [2] — [5] button is pressed the adjustable audio
items are switched among ranges of all stage section's tables on
the following pages.
6
Adjust the Audio Control item
Press the [
4] or [¢] button.
Each time the button is pressed the setting switches as shown
below.
7
Exit Audio Control mode
Press the [RTN] button.
• The loudness setting can also be adjusted by pressing the [4]
button.
• *This mode is available only when
is ON.
1
Select the source for adjustment
Press the [SRC] button.
2
Select the key function section
Press the [NEXT] button.
Repeatedly press the button until "AUD" is displayed above the
[2] button.
Refer to
3
Enter Audio Control mode
Press the [2] ("AUD") button.
4
Select the Adjustment item section
Press the [NEXT] button.
Repeatedly press the button until the desired Adjustment item is
displayed above the [2] — [5] button.
1st section
Adjustment Item
Button Display
Bass
[2]
"BASS"
Middle
[3]
"MID"
Treble
[4]
"TRE"
Balance & Fader
[5]
"BL/F"
2nd section
Adjustment Item
Button Display
High Pass Filter
[2]
"HPF"
Low Pass Filter
*
[3]
"LPF"
Loudness
[4]
"LOUD"
Non-Fading
*
[5]
"N-F"
3rd section
Adjustment Item
Button Display
Volume offset
[2]
"VOFF"
Audio Control
General features
— 12 —
English
KDC-M7024_U.S 02.12.11 3:02 PM Page 12