Kenwood DPX-6020 - Manual (Page 7)

This function allows you to turn down the volume quickly.
Turning Attenuator On/Off:
Press the ATT button to switch the attenuator on and off.
When the attenuator is on, the ATT indicator blinks.
When the attenuator is off, the volume returns to the original
level.
Turning the volume all the way down deactivates the attenuator
function.
NOTE
Attenuator
Increasing Volume:
Press the 5 button to turn up the volume.
Decreasing Volume:
Press the ∞ button to turn down the volume.
Volume
— 7 —
Adjust the clock.
When the clock is not displayed, first press the DISP button to
display "Clock".
Press the DISP button for at least two seconds to enter the
clock adjustment mode.
• Adjusting the hours
Press the FM button to advance the hours, or press the AM
button to make the hours go back.
• Adjusting the minutes
Press the ¢ button to advance the minutes, or press the
4 button to make the minutes go back.
Press the DISP button to end the clock adjustment mode. 4
3
2
1
Adjusting Clock
Adjust various sound levels.
Press the AUD button twice to enter the control mode.
Press either the 4 or ¢ button.
Each time the button is pressed, the adjustment mode will
change as follows:
Pressing the
¢ button advances the display, and pressing the
4 button reverses it.
Press the FM/AM button.
Look at the table to adjust the mode being displayed.
Press the AUD button to end the control mode. 4
Adjustment
mode
(Display)
Balance
("Balance")
Fader
("Fader")
Non-Fading
Preout Level
("N-F")
Left channel emphasized.
Rear channel emphasized.
Right channel emphasized.
Front channel emphasized.
AM button FM button
Operation of Audio control button
Non-fading sound
emphasized. Non-fading sound
reduced.
3
"Balance"
"Fader" "N-F" (only when being switched)
2
1
Audio Control Setting
DPX-6020_K_U.S 01.12.25 1:57 PM Page 7