Kenwood DPX-6020 - Manual (Page 35)

• Number/letter entry buttons
Press buttons #1-6 to recall preset stations.
During direct access tuning, use these buttons to input the
frequency of the station.
Use to enter letters (alphabetical) during station name preset.
• 4/¢ (TUNE) buttons
Press the 4 button to decrease the frequency.
Press the ¢ button to increase the frequency.
Use to move the cursor left or right during station name preset.
• AM/FM button
Press the AM button to select the AM band.
Press the FM button to select and switch between FM1, FM2,
and FM3 bands.
During station name preset, selects digits and symbols.
• DIRECT/OK button
Selects the direct access tuning mode, used to input frequencies
directly. Press this button again to cancel the mode while it is
operating.
During station name preset, stores the already input data in
memory and ends the input mode.
During Station name preset play mode, selects station.
• DNPP/SBF button
Enters and cancels the Station Name Preset Play mode.
• 38 button
Selects the type of characters at the time of entering the station
name.
Tuner features Press the + button to turn the volume up.
Press the – button to turn the volume down.
• SRC button
Each time you press the SRC button, the mode switches as
follows:
• The mode switches to the next mode from any mode which
cannot be used.
• The external disc control mode will differ depending on the unit
that is connected.
• ATT button
Turns down the volume quickly. To return the volume to its
original level, press the button again. Turning the volume all the
way down also cancels attenuation.
• button
Each time you press this button, the panel slides one step at a
time.
When the panel has been slid down completely, press this
button to close the panel.
NOTE
▼
Tuner mode
▼
Tape mode
▼
External disc control mode
▼
CD mode
▼
Standby mode
— 35 —
DPX-6020_K_U.S 01.12.25 1:57 PM Page 35