beautypg.com

Connecting the antenna data cable, Connecting the antenna power cable – KVH Industries TracVision 6 User Manual

Page 28

background image

Connecting the Antenna Data Cable

Find the TracVision 6 data cable where it comes through the
panel cutout made earlier. Wire the data cable to the switchplate
as shown in Figure 2-13. The connector board is etched with the
same wire color identification to make the wiring process easier.

Connecting the Antenna Power Cable

Find the TracVision 6 power cable where it comes through the
panel cutout made earlier. Wire the antenna unit power cable to
the switchplate connectors as shown in Figure 2-14. After wiring
the power cable, connect the power indicator lamp, also as noted
in Figure 2-14. After both the power cable and lamp are properly
wired, carefully insert the lamp into its socket immediately below
the switchplate connectors.

54-0166

24

TracVision 6 Technical Manual

BLU/WHT

Not Used

WHT/BLU

Not Used

BRN/WHT

PC GND

WHT/BRN

PC TXD

ORG/WHT

PC RXD

WHT/ORG

RF GND

GRY/WHT

RF RXD

WHT/GRY

RF TXD

GRN/WHT

Not Used

WHT/GRN

Not Used

Data Cable
to Antenna

+12 VDC (Red)
+12 VDC – Lamp

Ground (Black)
Ground – Lamp

Lamp Socket

Figure 2-13

Data Cable Wiring Arrangement

Figure 2-14

Wiring the Antenna Unit Power

Cable and Indicator Lamp

Cut back and insulate any unused
wires from the Data Cable.