Tracvision 6-hp technical manual addendum, 4 replacing the pcbs and fuses, 5 replacing the antenna gyro assembly – KVH Industries TracVision 6 User Manual
Page 2: Eco #7134)
1
54-0166 Addendum to Rev. C
TracVision 6-HP
Technical Manual Addendum
(ECO #7134)
The following changes apply to Revision C of the
TracVision 6-HP Technical Manual (KVH Part Number 54-0166).
The “=TV” configuration command printed in the manual is incorrect.
For your TracVision 6-HP system, the correct configuration command
is =TVG6HPT, not =TVG6HP.
You will need to enter the =TVG6HPT command whenever you replace
the main printed circuit board (PCB) or calibrate the antenna gyro, at
the steps noted below.
4.4
Replacing the PCBs and Fuses
Replacing the Main PCB
13. Type
=TVG6HPT
(
4.5
Replacing the Antenna Gyro
Assembly
Calibrating the Antenna Gyro
8. Type
=TVG6HPT
.