Kenwood eXcelon KDC-X789 - Manual (Page 14)

14 | KTC-HR300
Specifi cations
Analog FM tuner section
Frequency range (200 kHz space)
: 87.9 MHz – 107.9 MHz
Usable sensitivity (S/N: 30 dB)
: 11.2 dBf (1.0 μV/75 Ω)
Selectivity (±400 kHz)
: 65 dB
Quieting Sensitivity (S/N: 50 dB)
: 16.3 dBf (1.8 μV/75 Ω)
Frequency response
: 40 Hz – 15 kHz
Stereo separation (1 kHz)
: 40 dB
Digital FM tuner section
Frequency range (200 kHz space)
: 87.9 MHz – 107.9 MHz
Frequency response
: 20 Hz – 20 kHz
Analog AM tuner section
Frequency range (10 kHz space)
: 530 kHz – 1700 kHz
Usable sensitivity (S/N: 20dB)
: 20 μV
Digital AM tuner section
Frequency range (10 kHz space)
: 530 kHz – 1700 kHz
Frequency response
: 30 Hz – 15 kHz
General
Operating voltage
: 14.4 V (11 – 16 V allowable)
Current consumption
: 500 mA
Operating Environment
: 0 °C – +40 °C
Installation size (W × H × D)
: 164 Ч 34 Ч 109 mm
6-1/2 Ч 1-3/8 Ч 4-5/16 inch
Weight
: 1.1 lbs (500 g)
Specifications subject to change without notice.
FCC WARNING
This equipment may generate or use radio
frequency energy. Changes or modifications to this
equipment may cause harmful interference unless
the modifications are expressly approved in the
instruction manual. The user could lose the authority
to operate this equipment if an unauthorized change
or modification is made.
NOTE
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment may cause harmful interference to radio
communications, if it is not installed and used in
accordance with the instructions. However, there is
no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment
off and on, the user is encouraged to try to correct
the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a
circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV
technician for help.