Kenwood eXcelon KDC-X789 - Manual (Page 12)

12 | KTC-HR300
Installation
Connecting Wires to Terminals
Installation
Carpet
Accessory 3
Remove the backing from the velcro strips
(Accessory
3) and attach it to the bottom of the unit.
Install the switching unit on the carpet.
¤
• Please do not install the unit near the dashboard, the rear
tray, or other important components. Doing so could lead
to injury or accident should the unit come off due to a
shock and strike a person or an important component.
⁄
• Do not stick the velcro tape over the serial number.
KAB
SELECT SWITCH
5L
Control Unit
(5L connector)
Antenna Cable (Accessory 1)
KTC-HR300
To FM/AM antenna
Control Unit
(KAB connector)
Accessory 2
⁄
• The unit can only be connected to a control
unit with either 5L or KAB connector.
Set "SELECT SWITCH" 1 depending on a
connector type of a control unit to be
used.
When connecting to the control unit with
5L connector, set this switch down, and
when KAB connector set the switch up
(ON).
⁄
• KAB Connector units
DDX5034, DDX5034BT, DDX512, DDX514,
DDX712, DDX812, DNX5120, DNX512EX,
DNX5140, DNX6000EX, DNX6140, DNX7120,
DNX8120, KVT-512, KVT-514
(As of January, 2009)
⁄
• Do not remove the
ferritic core attached
to the cable.