Troubleshooting – KTM 450 SMR User Manual
Page 69

TROUBLESHOOTING
67
Faults
Possible cause
Measure
Engine has no idle.
Ignition system defective
ಥ
Have ignition system checked.
Engine does not speed up.
Carburetor running over because float
needle dirty or worn
ಥ
Have carburetor checked.
Loose carburetor jets
ಥ
Have carburetor checked.
Electronic ignition adjustment defective
ಥ
Have ignition system checked.
Engine has too little power.
Fuel feed interrupted
ಥ
Check tank vent.
ಥ
Clean fuel tap.
ಥ
Clean carburetor.
Air filter very dirty
ಥ
Clean the air filter. (
P. 59)
Exhaust system leaky, deformed or too lit-
tle glass fiber yarn filling in main silencer
ಥ
Check exhaust system for damage.
ಥ
Change glass fiber yarn filling of main
silencer. (
P. 58)
Valve clearance too little
ಥ
Have valve clearance adjusted.
Electronic ignition adjustment defective
ಥ
Have ignition system checked.
Engine stalls or is popping into the carbu-
retor
Lack of fuel
ಥ
Clean and check the fuel system and
carburetor.
Engine takes in bad air
ಥ
Check rubber sleeves and carburetor
for tightness.
Engine overheats.
Too little coolant in cooling system
ಥ
Check the cooling system for leakage.
ಥ
Check the coolant level. (
P. 55)
Too little air stream
ಥ
Switch off engine when standing.
Radiator fins very dirty
ಥ
Clean radiator fins.
Foam formation in cooling system
ಥ
Drain the coolant. (
P. 56)
ಥ
Refill the coolant. (
P. 56)
Bent radiator hose
ಥ
Replace the radiator hose.
High oil consumption
Engine vent hose bent
ಥ
Route the vent hose without bends or
replace it if necessary.
Engine oil level too high
ಥ
Check the engine oil level. (
P. 62)
Engine oil too thin (low viscosity)
ಥ
Change the engine oil and oil filter,
and clean the oil screen. (
P. 63)
Battery discharged
Battery is not charged by generator
ಥ
Check electrical system.