KTM 450 SMR - Manual (Page 49)

MAINTENANCE WORK ON CHASSIS AND ENGINE
47
500210-10
ಥ Holding the front wheel, withdraw the wheel spindle. Take the front wheel out of
the fork.
Info
Always lay the wheel down in such a way that the brake disc is not dam-
aged.
500211-10
ಥ Remove the spacing sleeves ‘ .
Fitting front wheel ‘
x
Warning
Danger of accidents ಗReduced braking due to oil or grease on the brake discs.
ಥ Always keep the brake discs free of oil and grease, and clean them with brake cleaner when necessary.
500211-11
ಥ Check parts for damage and wear. Replace damaged or worn parts.
ಥ Clean and grease shaft seal rings ‘ and bearing surface ‘ of the spacing sleeves.
Long-life grease ( P. 84)
ಥ Fit the spacing sleeves.
500212-10
ಥ Lift the front wheel into the fork, position it, and insert the wheel spindle.
ಥ Mount and tighten screw ‘ .
Specification
Screw, front wheel spindle M24x1,5 40 ‘Nm
(29.5 ‘lbf‘ft)
500208-10
ಥ Position the brake caliper. Fit and tighten screws ‘ with washers ‘ .
Specification
Screw, front brake caliper M10x1,25 40 ‘Nm
(29.5 ‘lbf‘ft)
Loctite ® 243™