KTM 450 SMR User Manual
Page 34

0
0
B
B
0
0
A
A
0
0
2
2
0
0
1
1
MAINTENANCE WORK ON CHASSIS AND ENGINE
32
Dismount the start number plate
500191-10
ಥ
Remove screw
and take off clamp.
ಥ
Remove screw
. Remove the start number plate.
Fitting the start number plate
500191-11
ಥ
Check parts for damage and wear. Replace damaged or worn parts.
ಥ
Position the start number plate. Mount and tighten screw
.
Specification
Remaining screws, chassis
M6
10
Nm
(7.38
lbfft)
Info
Take care with the contact of the holding lug at the fender.
ಥ
Position brake line. Put the clamp on, mount and tighten screw
.
Handlebar position
400271-11
On the upper triple clamp, there are 2 holes at a distance of
to each other.
Drilling distance A
15
mm (0.59in)
The holes on the handlebar support are placed at a distance of
from the center.
Drilling distance B
3.5
mm (0.14in)
The handlebar can be mounted in 4 different positions. This enables you to mount the
handlebar in the position most suitable for the rider.
Adjusting handlebar position
x
400271-10
ಥ
Remove the four screws
. Remove the handlebar clamp. Remove the handlebar
and lay it to one side.
Info
Protect the motorcycle and its attachments from damage by covering them.
Do not bend the cables and lines.
ಥ
Remove the two screws
. Remove the handlebar support.
ಥ
Place the handlebar support in the required position. Fit and tighten the two
screws
.
Specification
Screw, handlebar support
M10
40
Nm
(29.5
lbfft)
Loctite
®
243™
Info
Position the left and right handlebar supports evenly.
ಥ
Position the handlebar.
Info
Make sure cables and wiring are positioned correctly.
ಥ
Position the handlebar clamp. Fit and evenly tighten the four screws
.
Specification
Screw, handlebar clamp
M8
20
Nm
(14.75
lbfft)