Kenwood KDC-6015 - Manual (Page 30)

When this system is set to on, the sound coordinate factors
(Bass Frequency, Bass quality, Bass extension, and Treble
frequency) appear during the audio control mode.
Display and setting:
"Kex/ec4/dB (set) ON" : The sound coordinate factors appear
and can be adjusted.
"Kex/ec4/dB (set) OFF" : The sound coordinate factors are not
appeared.
KEX/ec4/dB (Sound Coordinate system)
Function of the KDC-X615
Switch the preout between the rear and non-fading. When you
switch to non-fading, you can adjust the volume separately.
The factory default is rear preout.
Display and setting:
"SWPRE Rear" : Rear preout
"SWPRE N-Fad" : Non-fading preout
You cannot use the high-pass filter with non-fading preout.
NOTE
Switching preout
Display and setting:
"BLK MASK/BMSK ON" : The display will turn on by using only
the upper part of the display and the
IN indicator (KDC-X615/6015 only).
"BLK MASK/BMSK OFF" : The display will turn on by using the
whole part of the display.
This function allows you to turn off the lower part of the
display if there is too much information in the display.
Black Mask
You can turn the movement of graphic display on and off.
The initial setting is ON.
Display and setting:
"Graphic/GRAP ON" : The graphic display works.
"Graphic/GRAP OFF" : The graphic display does not work.
Switching Graphic Display
Function of the KDC-X615/KDC-6015
You can dim the display.
The dimmer function is not available for units if the dimmer wire
is not connected.
Display and setting:
"Dimmer ON" : The dimmer setting is on.
"Dimmer OFF" : The dimmer setting is off.
NOTE
Dimmer
Function of the KDC-X615/KDC-6015
This adjustment permits easy viewing of the display.
Display and setting:
"Contrast 0" – "Contrast 10"
The initial setting value is "5" .
NOTE
Contrast Adjustment
Menu settings
— 30 —
English
KDC-X615_U.S_K_r6 00.12.26 3:45 PM Page 30