Kenwood DNX SERIES DDX6046BT - Manual (Page 74)

74 DNX SERIES DNX6960/DNX6160/DNX6020EX/DNX6460BT/DNX5160
Navigation Setup
You can set Navigation parameters.
Display the Navigation Setup screen 1
Touch [ ] > [ ] > [Navigation]. (page 62)
Set each item 2
[NAV Interrupt Speaker] Selects speakers
used for voice guidance of the navigation
system.
(
"Front All")
"Front L": Uses the front left side speaker for
voice guidance.
"Front R": Uses the front right side speaker for
voice guidance.
"Front All": Uses both front speakers for voice
guidance.
[NAV Voice Volume] Adjusts the volume for
voice guidance of the navigation system.
(
DNX series: "25", DDX series: "21")
[NAV Mute] Mutes the volume during voice
guidance of the navigation system.
(
"ON")
When turned "ON", the volume level drops for
voice guidance.
[Navigation Input] Selects a navigation
system connection.
(
"RGB") (DDX series only)
"RGB": Allows the Kenwood’s Navigation
System to connect via its interface
cable.
"AV-IN": Allows a third-party navigation system
to connect via the AV INPUT1 port.
"OFF": Must be used if no navigation system is
connected.
(The navigation display is cancelled
when the AV source is switched.)
[On Screen Navigation] Sets an on-screen
display of the navigation screen. ( "OFF")
(DDX series only)
"Auto": Information is displayed for 5 seconds
when updated.
"OFF": Information is not displayed.
⁄
[On Screen Navigation] •
It can be set only when [Navigation Input] is set to "AV-
IN".
Setup Menu