Kenwood DNX SERIES DDX6046BT - Manual (Page 60)

60 DNX SERIES DNX6960/DNX6160/DNX6020EX/DNX6460BT/DNX5160
Equalizer Control
You can set up the equalizer.
Display the Equalizer screen 1
Touch [ ] > [ ] > [Equalizer]. (page 59)
Set each item 2
[SystemQ] Selects an equalizer curve type.
You can select any of the following equalizer
curves.
"Natural"/ "Rock"/ "Pop"/ "Easy"/ "Top40"/
"Jazz"/ "User"
⁄
"User": •
Your own tone curve can be created. See Setup> (page 60).
[SystemQ-EX] Selects items to be adjusted for
tone curve setup.
If selected "OFF", only Level can be set up for
tone curves.
[Tone] Displays the Tone curve setup screen.
(page 60)
Tone Setup
You can set a Tone curve.
Display the Equalizer screen 1
Touch [ ] > [ ] > [Equalizer]. (page 59)
Display the Tone Control screen 2
Set the Tone 3
[Bass] Bass adjustment items are displayed.
[Middle] Middle adjustment items are
displayed.
[Treble] Treble adjustment items are displayed.
[Flat] Tone level becomes 0 (flat).
[FREQ] Sets the Center frequency.
[Level] Sets the level.
[Q Factor] Sets the Q factor. (Only [Bass] and
[Middle] can be set)
[Bass DC EXT] Bass DC Extend settings. (Only
[Bass] can be set)
If turned "ON", it extends the bass center
frequency to the low register by approximately
20%.
[SW Level] Adjusts the subwoofer volume.
The setting is available when subwoofer is set
to "ON". See (page 75).
Audio Control