Kenwood DNX SERIES DDX6046BT - Manual (Page 70)

70 DNX SERIES DNX6960/DNX6160/DNX6020EX/DNX6460BT/DNX5160
Registering Bluetooth Unit
Registers the Bluetooth unit to be connected.
Display the Bluetooth Setup screen 1
Touch [ ] > [ ] > [Bluetooth SETUP].
(page 62)
Display the Connect Device List screen 2
⁄
[A2DP Connect Device] •
Only for DNX5160 and DDX516 with optional
Bluetooth unit KCA-BT200 connected.
Search for a Bluetooth unit 3
1 1 1
1 Displays the registered Bluetooth units.
The busy service becomes active. The available
service becomes inactive.
[ ] When appears, the text display is
scrolled by touching it.
[Search] Searches for a Bluetooth unit.
[SP DEV] Registers a Bluetooth unit that
cannot be registered by normal register
(pairing) operation.
⁄
A new device cannot be registered if there are •
already 5 Bluetooth units registered. Delete
unnecessary registration. See Connection> (page 72).
Select the Bluetooth unit to register 4
1 1 1
1 Displays the searched Bluetooth unit.
[Search] Searches for a Bluetooth unit.
[Cancel] Cancels searching of Bluetooth unit.
Enter PIN code 5
1 1 1
1 Enters a code number using the keypad.
[Enter] Confirms the entered PIN code. Enter
the PIN code specified for the Bluetooth unit
you are registering.
This button will not be active until at least four
PIN code digits have been entered.
[Cancel] Cancels registration of PIN code.
[Clear] Clears the code number.
⁄
You can also register from the Bluetooth unit side. For •
the PIN code necessary for registration, see Bluetooth Unit PIN Code> (page 71).
If the error message appears even though the PIN code is
•
correct, try .
The screens used in this manual are for models with
•
optional Bluetooth unit KCA-BT200 connected.
Models with built-in Bluetooth function do not have
some buttons described in this manual.
Setup Menu