Konica Minolta BIZHUP C451 - Manual (Page 206)

Setting up the PostScript driver (Windows) 6
C451 6-9
2
Note
“12 × 18” paper size is one size larger than A3 paper size at 504.8 × 457.2
mm.
To print on paper sizes other than the standard sizes, be sure to set the
custom paper sizes in Custom Size Settings first.
When “W” is selected for each standard paper size from the printer driv-
er, the data can be centered and printed.
For example, if A4 size data is created and you want to center and print
on A3 size paper, select “A4W” as the paper size and “Tray 1” or “Bypass
Tray” as the paper tray from the printer driver.
To print, load A3 size paper in the tray (“Tray 1” or “Bypass Tray”) of this
machine that was specified from the printer driver, and then specify the
settings described below from [Basic (Paper)] – [Change Tray Settings] –
[Wide Paper] in the control panel.
“A4W”.
Enter the A3 paper size (420.0 × 297.0) in [Change Size].
Specifying a custom size
When printing on paper of a custom size, you can specify the paper size val-
ues by following the procedure described below.
1
From the “Original Size” or the “Paper Size” drop-down list, select
“Custom Size”.
The Custom Size Settings dialog box appears.
2
Specify settings for the following:
– Width: Specifies the width of the custom paper size according to
the selected measurement unit.
– Length: Specifies the length of the custom paper size according to
the selected measurement unit.