Konica Minolta BIZHUP C451 - Manual (Page 109)

Setting up network printing 3
C451 3-36
11
Use the NetWare server console to load MONITOR.NLM.
12
Select the connection information and, in the active connection col-
umn, check that the created PServer is connected.
2
Reminder
When turning the power off, then on again, wait at least 10 seconds be-
fore turning the power on again; otherwise, this machine may not function
properly.
For NetWare 5.x/6 Novell Distributed Print Service (NDPS)
2
Note
Before specifying settings for NDPS, check that the NDPS broker and
NDPS manager have been created and loaded.
Also, before performing the following procedure, check that the TCP/IP
protocol has been set in the NetWare server, and check that the IP ad-
dress has been set for this machine and that this machine is on.
1
Log on to NetWare as an administrator from a client computer.
2
Start up NWadmin.
3
Right-click the organization or organizational unit container where you
will create the printer agent, and then click “NDPS Printer” on the “Cre-
ate” sub-menu.
4
In the “NDPS Printer Name” box, enter the printer name.
5
In the “Printer Agent Source” column, select “Create a New Printer
Agent”, and then click the [Create] button.
6
Check the printer agent name, and then in the “NDPS Manager Name”
box, browse through the NDPS manager names, and register one.
7
In “Gateway Types”, select “Novell Printer Gateway”, and then register
it.
8
In the Configure Novell PDS for Printer Agent window, select “(None)”
for the printer type and “Novell Port Handler” for the port handler type,
and then register the settings.