Kenwood DPX-3050 - Manual (Page 10)

1 Enter the Audio Control mode
Press the [AUD] button for at least 1 second.
"AUD mode" is displayed.
2 Select the Audio item for adjustment
Press the [FM] or [AM] button.
Each time the button is pressed, the items that can be adjusted
switch as shown below.
3 Adjust the Audio item
Press the [
4] or [¢] button.
Audio Control
The can be preset.
1 Refer to (page 10) to
adjust the Equalizer type.
2 Preset the adjusted value
Press the [1] — [3] button for at least 2 seconds.
Recalling a setting value
1 Enter the Equalizer Control mode
Press the [EQ] button.
"EQ PRO" is displayed.
If "EQ EASY" is displayed, refer to (page 24) to
set the mode to "EQ PRO".
2 Recall the setting value
Press the [1] — [3] button.
Memory preset of adjustment of Equalizer type
Adjusting the effect of an Equalizer type selected in Control> when is "PRO".
1 Refer to (page 9) to select the Equalizer
type.
2 Select the item for adjustment
Press the [FM] or [AM] button.
Each time the button is pressed, the items that can be adjusted
switch as shown below.
3 Adjust the item
Press the [
4] or [¢] button.
Adjustment Item Display Range
Bass Center Frequency "Bas F" 60/70/80/100 or 150 Hz
Bass level "Bas LV" –12 — +12 dB
Bass Q Factor "Bas Q" 1.00/1.25/1.50/2.00
Bass Extend "EXT" On/Off
Middle Center Frequency "Mid F" 0.5/1.0/1.5/2.0 kHz
Middle level "Mid LV" –12 — +12 dB
Middle Q Factor "Mid Q" 1.0/2.0
Treble Center Frequency "Tre F" 10.0/12.5/15.0/17.5 kHz
Treble level "Tre LV" –12 — +12 dB
• According to the Bass Q Factor setting value, the frequencies that
can be set in Bass Center Frequency change as shown below.
Bass Q Factor
Bass Center Frequency
1.00/1.25/1.50 60/70/80/100
2.00 60/70/80/150
• When the Bass Extend is set to ON, low frequency response is
extended by 20%.
Adjustment of Equalizer type at PRO
General features
— 10 —
English
DPX-MP4050(M-TKR)(E) 2003.02.14 09:03 AM Page 10