Kodak DUPLEX DL2100 - Manual (Page 20)

19
7. To remove a sheet just
entering the fuser:
a. Separate the trailing edge of
the sheet from the belt.
b. Move the paper release
lever for the fuser toward
the front, and remove the
sheet.
c. Release the lever.
8. If the sheet is well advanced
into the fuser:
a. Move both fuser release
levers toward the front of the
printer to release the fuser.
Hold the fuser by the handle
and lift it out of the printer.
b. Place the fuser on a flat
surface.
c. Move the paper release lever
and pull the jammed paper
from the fuser.
d. Replace the fuser unit and
move the fuser release levers
toward the rear of the printer.
See “Replacing the Fuser” on
page 15.