Kenwood CD-206 - Manual (Page 20)

CD-206/204/203/DPF-R6010/R4010/R3010 (En)
20
Blinks. CD-206/DPF-R6010
D E T I D S I ? C
The following procedure allows to record a CD within the
specified tape length so that no music is interrupted in the
middle at the ends of sides A and B.
Editing
Preparation
1
Light the “EDIT” indicator.
÷ Load a disc in the CD player.
÷ Check that the unit is in the normal play
TRACK mode. !
: Keys and controls used in the operations described on this page.
Select the disc.
2
Do this operation in the stop mode.
Go to step 2 within 8 seconds.
If more than 8 seconds have elapsed,
press the key again.
Go to step 3 within 8 seconds.
3
Press the numeric keys as shown below.
30-minute tape : 000)
46-minute tape : 00006
÷ The interval length can be adjusted with the skip keys 4 and ¢ in
units of one minute (to a maximum of 99 minutes).
÷ If you commit a mistake in time entry, press the P.MODE key and
restart the procedure from the beginning.
Enter the recording time of the tape.
When using the numeric keys:
2
Set the entry.
1
Select the time.
\
Hereafter the illustration of the common parts
on the front panel is of CD-206/DPF-R6010.
EDIT
DISC 1 DISC 2 DISC 3 DISC 4 DISC 5
EDIT TIME DISP.
Main unit Remote control unit
4 ¢
1 2 3
4 5 6
7 8 9
0 +10
When using the TIME DISPLAY key:
Normal EDIT
Normal EDIT: Edit from one disc.
MULTI EDIT: Edit and record from several discs.
PGM
5 4 3 2 1
MULTI
EDIT
D E T I D S I 3 C C 4 - 6
10 9 8 7 6
5 4 3 2 1
C _ 4 6
CD-204/203/DPF-R4010/R3010
CD-206/DPF-R6010
CD-204/203/DPF-R4010/R3010
Blinks.
÷ Automatic editing is executed for side A and side B,
÷ By pressing the TIME DISPLAY key the set time-length intervals will
change in this order:
CD-206/DPF-R6010
CD-204/203/DPF-R4010/R3010
Light up.
÷ By pressing the TIME DISPLAY key the set time-length intervals will
change in this order:
"46 =54=60=74=90= ?? "
=
"46 =54=60=90= - - "
=
REMOTE CONTROL UNIT
RC-P0601
«
EDIT