Kompernass KH 2391 - Manual (Page 12)

14 GB/IE
• Place the rear left-hand edge of the control
panel 1 on the control panel attachment point
ds on the front of the device.
• Ensure that the plug-in connection strip cr is
positioned in front of the connection socket dl .
• Carefully press the rear right-hand edge of the
control panel 1 against the control panel
attachment point dp until it distinctly locks into
place.
• Fold the control panel 1 upwards and allow it
to lock into place.
L Operation
L Switching on
• Press the button cp .
The factory settings of the device are as follows:
• The word
[WELCOME] appears in the display
window 9 .
• The buttons are illuminated in blue (these can
be adjusted on two levels).
• Press the
MU/DIM
button bo for 2 seconds. If it
is pressed again for 2 seconds the brightness
of the display window is increased once more.
- The tuner is activated and [FM1] (1st FM
band), [87.50] (station frequency) appears
in the display window 9 . [AF] flashes.
- The loudspeakers play back the reception
from the tuner.
• Turn the “SEL / VOL” control knob co to adjust
the volume as desired.
L Switching off
• Press the button cp . The background
illumination of the control panel 1 goes off
and the time appears in the display window 9 .
When the radio is switched off it stores all
settings from the last time it was operated. The
device automatically adjusts the time with the
help of the radio signals received. When the
radio is switched on again it plays back the last
audio storage medium used or the tuner.
L Selecting and adjusting the sound
VOL: Volume of the loudspeakers
• Adjust the loudspeakers to the desired volume
by turning the “SEL / VOL” control knob co .
BAS: Bass (lower range of the loudspeaker sound)
• Press THE “SEL / VOL” control knob
co until
[BAS] appears in the display window 9 .
• Turn the “SEL / VOL” control knob co to set the
desired bass level.
Values between [-7] and [7] can be selected.
TRE: Treble (higher range of the loudspeaker sound)
• Press the “SEL / VOL” control knob
co repeatedly
until [TRE] appears in the display window 9 .
• Turn the “SEL / VOL” control knob co to set the
desired treble level.
Values between [-7] and [7] can be selected.
BAL: Balance (difference in volume between the
left [L] and right [R] loudspeakers)
• Press the “SEL / VOL” control knob co until
[BAL] appears in the display window 9 .
• Turn the “SEL / VOL” control knob co to set the
desired balance.
Values between [10L] and [10R] can be
selected. The mean value is [0].
FAD: Fading (difference in volume between the
front [F] and rear [R] loudspeakers)
• Press the “SEL / VOL” control knob co until
[FAD] appears in the display window 9 .
• Turn the “SEL / VOL” control knob co to set the
Installation / Operation
KH2391_Content_UK.indd 14 05.09.2006 14:49:13 Uhr