General operation – Kenwood DPX-MP3110 User Manual
Page 8
8
|
DPX-MP5110U/DPX-MP4110/DPX-MP3110
General Operation
Speaker Setting
Fine-tuning so that the System Q value is optimal
when setting the speaker type as follows;
Speaker type
Display
OFF
“SP Off”
For 5 & 4 in. speaker
“SP 5/4”
For 6 & 6x9 in. speaker
“SP 6*9/6”
For the OEM speaker
“SP OEM”
1
Enter Standby
Press the [SRC] button.
Select the “STANDBY” display.
2
Enter Speaker Setting mode
Press the Control knob.
“SP SEL” is displayed.
3
Select the Speaker type
Turn the Control knob.
4
Exit Speaker Setting mode
Press the Control knob.
Sound Enhancer Select
You can play back adding gorgeous heavy bass to
the sound.
1
Enter the Sound Effect mode
Press the [SE] button.
"SE SEL" is displayed.
2
Select the Sound effect item
Turn the Control knob.
Sound effect
Display
Returns to the normal sound without Sound effect.
“SE Off“
Moves the sound image up a notch and adjusts bass
“SE Low”
Moves the sound image up two notches and adjusts
bass.
“SE High“
Changes to the value set in
“SE User“
When the Sound effect is ON, the “SE“ indicator is
ON.
3
Exit the Sound Effect mode
Press the [SE] button.
Audio Setup
You can set Sound system, such as follows;
Adjustment Item
Display
Range
Front High Pass Filter
“HPF”
Through/40/60/80/100/120/
150/180/220 Hz
Rear High Pass Filter
“HPR”
Through/40/60/80/100/120/
150/180/220 Hz
Low Pass Filter
“LPF”
50/60/80/100/120/Through Hz
Subwoofer Phase
“PHAS”
Reverse (180°)/ Normal (0°)
Volume offset
“V-Off”
–8 — ±0 (AUX: -8— +8)
Loudness
“LOUD”
Off/On
Dual Zone System
“2ZON”
Off/On
⁄
• Volume offset: Sets each source’s volume as a difference
from the basic volume.
• Loudness: Compensates for low and high tones during
low volume. (Only the low tone is compensated for
when the tuner is selected as a source.)
• Dual Zone System
Main source and sub source (Auxiliary input) output
Front channel and Rear channel separately.
- Set up the channel of sub source by “Zone2” of