Kenwood DPX-MP3110 - Manual (Page 21)

– +
P.CONT
MUTE
ILLUMI
ANT.
CONT
REMO.CONT
English | 21
Connecting Wires to Terminals
Battery
Ground wire (Black) - (To car chassis)
Fuse (10A)
Wiring harness
(Accessory1)
Ignition wire (Red)
Battery wire (Yellow)
ACC
Car fuse box
If no connections are made, do not let the wire come out from the tab.
To front left speaker
To front right speaker
To rear left speaker
To rear right speaker
White/Black
White
Gray/Black
Gray
Green/Black
Green
Purple/Black
Purple
Ignition key switch
Car fuse box
(Main fuse)
To Kenwood disc changer/
External optional accessory
Motor antenna control wire (Blue)
TEL mute wire (Brown)
Connect to the terminal that is grounded when either the
telephone rings or during conversation.
⁄
To connect the Kenwood navigation system, consult
your navigation manual.
Power control/Motor antenna control wire
(Blue/White)
Connect either to the power control terminal when using
the optional power amplifier, or to the antenna control
terminal in the vehicle.
FM/AM antenna input
Dimmer control wire (Orange / White)
To car light control switch
Depending on what antenna you are using, connect either
to the control terminal of the motor antenna, or to the
power terminal for the booster amplifier of the film-type
antenna.
Front preout
Rear/SubWoofer preout
Steering remote control (Light Blue/Yellow)
To use the steering wheel remote control feature, you need to an exclusive
remote adapter (not supplied) matches your car is required.
When this terminal is not in use, leave its cap on.