Kenwood eXcelon KDC-X590 - Manual (Page 43)

English | 43
Screwing the Faceplate on the Unit
If you want to fasten the faceplate to the main
unit so that it does not fall off.
1 Refer to the section
frame> (page 44) and then remove the hard
rubber frame.
2 Drop open the faceplate by pressing the Release
button.
3 Tighten the screw (ш2 Ч 5 mm) (Accessory 5)
and bracket (Accessory 6) in the hole shown on
the diagram.
Accessory 5
Accessory 6
4 Tighten the screw (ш2 Ч 5 mm) (Accessory 5)
and bracket (Accessory 7) in the hole shown on
the diagram.
Accessory 5
Accessory 7
• Never insert the screws in any other screw hole than the
one specified. If you screw them in another hole, it will
contact and may cause damage to the mechanical parts
inside the unit.