Kenwood eXcelon KDC-X590 - Manual (Page 41)

To USB device
English | 41
ANT.
CONT
MUTE
P.CONT
ILLUMI
FRONT L
FRONT R
REAR L
REAR R
– +
FRONT
Connecting Wires to Terminals (KDC-MP532U)
Battery
Ground wire (Black) - (To car chassis)
FM/AM antenna input
Fuse (10A)
Wiring harness
(Accessory
1)
Ignition wire (Red)
Battery wire (Yellow)
ACC
Car fuse box
If no connections are made, do not let the wire come out from the tab.
When using the optional power amplifier,
connect to its power control terminal. Power control wire (Blue/White)
Motor antenna control wire (Blue)
Depending on what antenna you are using,
connect either to the control terminal of the
motor antenna, or to the power terminal for the
booster amplifier of the film-type antenna.
To front left speaker
To front right speaker
To rear left speaker
To rear right speaker
White/Black
White
Gray/Black
Gray
Green/Black
Green
Purple/Black
Purple
Ignition key switch
Car fuse box
(Main fuse)
TEL mute wire (Brown) Connect to the terminal that is grounded
when either the telephone rings or during
conversation.
To connect these leads, refer to
the relevant instruction manuals.
To connect the Kenwood navigation
system, consult your navigation manual.
To Kenwood disc changer/ External optional accessory
Front left output (White)
Rear left output (White)
Rear right output (Red)
Front right output (Red)
To car light control switch
Dimmer control wire (Orange / White)
USB connector
• Do not remove the cap when you do not use the
USB cable. The connector will cause the unit to
malfunction if it gets in touch with any metallic part
of the vehicle.
• Fasten the connector with the tape so that the cable
will not come off.