Kenwood DPX-5010 - Manual (Page 32)

— 32 —
English
Function set system
You can select the frequency to be cut of the high pass filter for
rear output.
Display and setting
“HPF-R Off/30/60/90/120/150/180/250” (Hz)
2. Frequency Setting of High Pass Filter for Rear Output
You can select the filter slope of the high pass filter.
Display and setting
“HPF Slope 12/18/24” (dB/Octave)
3. Filter Slope Setting of High Pass Filter
You can select the frequency to be cut of the low pass filter for
non-fading output.
Display and setting
“LPF Off/150/120/100/80/60” (Hz)
4. Frequency Setting of Low Pass Filter for Non-fading Output
You can select the filter slope of the low pass filter.
Display and setting
“LPF Slope 12/18/24” (dB/Octave)
5. Filter Slope Setting of Low Pass Filter
You can adjust the delay of sounds from front output during
using the DSP.
Display and setting
“T-Alg F OFF/0.5~18” (msec.)
6. Time Alignment for Front Output
You can adjust the delay of sounds from rear output during
using the DSP.
Display and setting
“T-Alg R OFF/0.5~18” (msec.)
7. Time Alignment for Rear Output
You can adjust the delay of sounds from non-fading output
during using the DSP.
Display and setting
“T-Alg NF OFF/0.5~18” (msec.)
8. Time Alignment for Non-fading Output
Adjust the bass boost level of the external amplifier using the
main unit.
Display and setting
"Amp Cont 1": Bass boost level is flat.
"Amp Cont 2": Bass boost level is low. (+6 dB)
"Amp Cont 3": Bass boost level is high. (+12 dB)
As of December 1998, the power amplifiers controllable by the
main unit are as follows:
KAC-X501F/PS501F/X401M/PS401M/X301T/PS301T/X201T/PS201T
NOTE
9. External Amp Control Setting
Function items in Other mode:
You can select the frequency to be cut of the high pass filter for
front output.
Display and setting
“HPF-F Off/30/60/90/120/150/180/250” (Hz)
1. Frequency Setting of High Pass Filter for Front Output