Kodak VIDEOMATE 2030P - Manual (Page 5)

5
Voltage Selection
Voltage Selection
Check voltage setting.
The Navitar VideoMate will be exported throughout the
world to countries with differing mains voltages. The
projectors are already set during manufacture to a fixed
main voltage.
100-200V mains:
Shipments to countries with 100 or 200V mains will be
equipped with a 5A fuse. A spare fuse for replacement is
also supplied.
220, 230, or 240V mains:
Shipments to countries with 220, 230 or 240V mains will
be equipped with 2.5A fuse. A spare fuse for replacement
is also supplied.
Before you switch on your projector ensure that voltage is
correctly adjusted! An incorrectly adjusted mains voltage
can damage the projector. The voltage selector must
show your country’s actual mains voltage. To set the
voltage selector simply turn the selector until the arrow of
your main voltage lines up with the arrow on the projector
housing. To fit or check the fuse, pull out the fuse holder
located beneath the main socket.