Kodak VIDEOMATE 2030P - Manual (Page 10)

10
Slide Tray Installation
Slide Tray Removal
To remove the tray from the projector without losing slides:
1. Hold the selector bar down and rotate the tray back to
the zero index position.
2. Lift the tray at a point opposite the index mark.
Slide Tray Jam
The tray may jam if a damaged slide is caught in the gate.
To release the tray:
1. Move the power switch to “off”.
2. Push the select bar down and the slide should come
up.
If the tray is still jammed:
1. Hold the release tab on the projector post out while
lifting the tray on the side opposite the index mark.
When the tray is removed, the select bar will release
the slide.
2. Invert the slide and rotate the bottom metal plate until
it locks into the zero position.
3. Turn the tray back upright and remove the lock ring. If
the slide in undamaged, return it to its proper slot.
Replace the lock ring and continue.