Kodak VIDEOMATE 2030P - Manual (Page 16)

16
Appendix
Appendix
Due to transportation, the image position might shift from
the factory setting. To correct this shift:
1. Remove the two plugs as shown in the figure below:
2. Using the Phillips screw driver, rotate screw #1 to
adjust the vertical position and screw #2 to adjust the
horizontal position.
3. Replace the hole plugs.
Do Not Remove Lower Plug
123456
123456
123456
123456
123456
123456
Adjustment for
Horizontal Movement
Screw #2
Adjustment for
Vertical Movement
Screw #1
Ektalite and Kodak are both trademarks of the Eastman Kodak Company.
VideoMate and Navitar are both trademarks of Navitar, Inc.