Kenwood DM-9090 - Manual (Page 27)

DM-9090 (En)
27
Each press switches the mode.
1 goes off (AUTO) : Track numbers are marked automatically.
£
2 MANUAL : Track numbers can be marked as desired.
£
3
4
÷ The unit enters record-pause mode automatically when the ¶ key is
pressed.
6
5
1 Play the source to be recorded.
2 Press the ¶ key.
3 Adjust the recording level and balance.
÷ Decrease the level if the red segments of the peak level meter light.
Extinguished in “AUTO” mode, lit in “MANUAL” mode.
Recording is not possible if the following characters are displayed.
“DISC FULL” : Disc is full
\Erase undesired tracks.
‚w
“PROTECTED” : The accidental erasure protect tab is open.
\Close it.
7
“PLAY ONLY” : A playback-only Mini Disc is loaded.
\Load a recordable Mini Disc.
9
÷ When the EDIT / SPACE key is pressed during recording, a track
number is inserted in that position.
÷ The eject (0)key is not accepted during recording.
After recording, eject the Mini Disc.
Start recording.
While “WRITING” is displayed, do not apply shock
or vibration to the unit because information is
being written on the Mini Disc.
Information is
being written. Mini Disc has been ejected.
Select “AUTO” or “MANUAL”.
Adjust the recording level. (Main unit only)
Recording level
(inner knob)
To attenuate
the L CH To attenuate
the R CH To increase
level To decrease
level
1 Press the ¶ key.
2 Play the source to be recorded from the
beginning.
Recording balance
(outer knob)
Recording (ANALOG input)
8 ¶
REC LEVEL REC BALANCE
MIN
L R
MAX
REC LEVEL REC BALANCE
MIN
L R
MAX
8 ¶
0
OVER ( − dB)
MANUAL
R
L
0 0 1
∞
15 9 12 7 5 1 3 40 30 21 18 0
SEARCH PGM
MONITOR
ANALOG
32kHz
2 1 3
48kHz
44.1kHz
DIGITAL
N O D I S C WRITING EJECT
AUTO/
MANUAL
Note Note
Pressing the pause ( 8) key also allows to can-
cel record-pause mode and start recording.