Kenwood DM-9090 - Manual (Page 24)

DM-9090 (En)
24
Each press switches the mode.
1 REC MODE : off
2 REC MODE : on (“D.REC LEVEL?” displayed.)
1 Switch the REC MODE on.
2 Select the setting adjustment mode.
3 Set the selection (by pressing the JOG
DIAL).
4 Adjust the setting value.
The recording-related settings can be adjusted precisely by selecting the proper display modes.
÷ The “D.REC LEVEL” and “FADE TIME” settings are not used during
analog source recording.
÷ Step 4 consists of adjusting the setting of the “Setting adjustment
mode” selected in step 2.
Selecting the setting adjustment mode
The modes are switched by rotating the JOG DIAL.
1 D. REC LEVEL? : Digital recording level setting.
2 AUTO TIME? : Setting of the time for detecting a no-sound
blank section during automatic track num-
ber marking.
3 AUTO LEVEL? : Setting of the level for detecting a non-
sound blank section during automatic track
number marking.
4 FADE TIME? : Setting of the fading time in fade-in and
fade-out.
5 REC = WRITING? : Setting of the UTOC writing after recording.
To change another setting, press the JOG
DIAL (PUSH SET knob).
(This returns to step
2 above.)
To end the setting adjustment, press the REC
MODE/CHARA. key again.
REC MODE key
Recording-related keys
REC MODE
/CHARA.
4 ¢
U P DOWN
PUSH SET
JOG DIAL
4 ¢
U P DOWN
PUSH SET
JOG DIAL
4 ¢
U P DOWN
PUSH SET
JOG DIAL