Kenwood DV-5700 - Manual (Page 54)

V
arious Setups
54
Chapter 6: Various Setups
"Digital Audio PCM Down
Conversion" Setting
(DVD VIDEO
disc only)
The player can output digital signal with maximum
sampling rate of 96 kHz from the digital audio output
connector. When a DVD disc recorded in high sampling
rate PCM is played, this setting makes it possible to select
whether the signal is converted into 48 kHz signal or
44.1 kHz/16-bit signal.
At the factory, the player has been set to "On" for AV
amplifiers incompatible with high sampling rate digital
signal connection. If the connected AV amplifier is
compatible with 96 kHz digital input, change the setting
to "Off".
Setting items
" " : Select to return to the previous screen.
"On" : Select to down-convert the signal to 44.1 kHz/
16-bit PCM signal. Select this setting when the
connected AV amplifier is incompatible with 96
kHz digital input.
¶ The analog output signals are also converted
accordingly.
"Off" : Select to skip down conversion. Select this
setting when the connected AV amplifier is
compatible with 96 kHz digital input. However, if
the disc inhibits the 96 kHz digital output, the
signal is down-converted even when this setting is
selected.
¶ With DVD AUDIO discs, the signal is always
output after down sampling conversion.
Operation procedure
1. Set the mode switch of the joystick remote to the
Purple position.
2. While the player is in stop mode, press
SET UP
1 and tilt
the joystick up or down to display the "SOUND"
menu of "SET UP MENU".
3. Press ENTER to open the setup screen.
4. In the setup menu, select "Digital Audio PCM Down
Conversion" by tilting the joystick up or down and
press ENTER .
7
7 On
7 Off
Digital Audio
Dolby Digital
Speaker Setting (Custom)
Speaker Setting (Quick)
Audio During Search
Dynamic Range Control
Audio Filter
DTS
MPEG
PCM Down Conversion
5. Select "On" or "Off" by tilting the joystick up or down,
then press ENTER to enter the selection in memory.
"Digital Audio Dolby Digital"
Setting
When a DVD recorded in Dolby Digital is played, this
setting makes it possible to select the audio signal from
the digital output connector of the player.
At the factory, the player has been set to "Bitstream" to
enable digital connection to an AV amplifier with built-in
Dolby Digital decoder. For the nonexistent decoders, set
the "Digital Audio" setting to "PCM".
Setting items
" " : Select to return to the previous screen.
"Bitstream" : The signal is output as a bitstream.
Select when connecting a component containing
Dolby Digital decoder.
"PCM" : The signal is converted onto 48 kHz (2CH.)
PCM signal before being output. Select when
connecting a component without Dolby Digital
decoder.
"SOUND" Setting