Kenwood TS-570D - Manual (Page 70)

1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
64
6 Adjust the TC500 trimmer to minimize the frequency
difference between the received 800 Hz tone and
the 800 Hz sidetone.
7 Re-install the protective cover on the PC board
(6 screws).
8 Re-install the bottom case (8 screws).
ACCESSING THE INTERNAL FUSE
1 Remove the top case (8 screws) from the
transceiver.
2 Remove the 12 screws that fasten the inner cover to
the chassis.
3 Open the inner cover.
• Be careful not to damage the speaker cable
connected to the PC board.
16 MAINTENANCE
INTERNAL ADJUSTMENTS
REFERENCE FREQUENCY CALIBRATION
Note:
◆ The transceiver is adjusted at the factory prior to shipping.
Unless necessary, DO NOT perform this adjustment.
◆ If you have installed the optional SO-2 unit, you cannot perform
this adjustment.
1 Set the following on the transceiver:
• Mode: CW
• AF control: Center
• Menu No. 20 (CW RX pitch): 800 Hz
• IF SHIFT control: Center
• Receive bandwidth {page 38}: 600 Hz
• RIT function: OFF
• Break-in function (VOX): OFF
2 Remove the bottom case (8 screws) from the
transceiver.
3 Remove the protective cover installed on the PC
board (6 screws).
4 Tune in a standard frequency station such as WWV
or WWVH at, for example, 10.000 or 15.000 MHz.
• Adjust the Tuning control so that the display
reads the exact frequency of the station.
• You should hear a beat tone of approximately
800 Hz.
• For 800 Hz:
f
af
= (f
display
/20.000 x
∆
f
reference
) + 800 Hz
where
∆
f
reference
is the shift from the 20 MHz
reference frequency
5 Close your CW key and you will hear a transmit
sidetone of approximately 800 Hz.
• This sidetone produces a double beat tone when
it combines with the received signal.
• Adjust the AF control to hear the double beat
clearly.
• For 800 Hz:
f
sidetone
= 800 Hz
±
50 ppm (= 800
±
0.04 Hz)
where
∆
f
reference
is the shift from the 20 MHz
reference frequency
TC500
Fuse (4A)