Kenwood TS-570D - Manual (Page 49)

1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
43
10 MEMORY FEATURES
STORING FREQUENCY RANGES
Memory channels 90 to 99 allow you to store frequency
ranges for VFO tuning and Program Scan. Program
Scan is described in the next chapter. To tune or scan
frequencies in a desired range only, store start and end
frequencies for that range in advance.
1 Press [A/B] to select VFO A or VFO B.
• “ t A” or “ t B” appears to show which VFO is
selected.
2 Select the end frequency and mode.
3 Press [A/B] to select the other VFO.
4 Select the start frequency.
5 Press [SPLIT].
• “SPLIT” appears.
6 Press [M.IN] to select Memory Scroll mode.
• To exit Memory Scroll mode and abort the
storage process, press [CLR].
7 Turn the MULTI/CH control, or press Mic [UP] or
[DWN] to select a memory channel in the range from
90 to 99.
• Entering a 2-digit number such as 90 using the
numeric keys can also be used to select a
channel.
8 Press [M.IN] again to store the data.
• The previous data stored in the channel is
overwritten.
■ Confirming Start/End Frequencies
Use this procedure to check the start and end
frequencies that you stored in channels 90 to 99.
1 Press [M/V] to enter Memory Recall mode.
2 Turn the MULTI/CH control, or press Mic [UP] or
[DWN] to select a memory channel.
3 Press [DOWN] to check the start frequency and
press [UP] to check the end frequency.
■ Programmable VFO
Using the start and end frequencies that you stored
in channels 90 to 99, Programmable VFO restricts
the frequency range that you can tune with the
Tuning control. One application of this function is to
help you operate within the authorized frequency
limits of your license.
1 Press [M/V] to enter Memory Recall mode.
2 Turn the MULTI/CH control, or press Mic [UP] or
[DWN] to select a memory channel.
Now you can only tune from the start frequency to
the end frequency
ERASING MEMORY CHANNELS
If there are memory channels that you will not recall in
the future, you may prefer erasing the contents of those
channels.
1 Press [M/V] to enter Memory Recall mode.
2 Turn the MULTI/CH control, or press Mic [UP] or
[DWN] to select a memory channel.
3 Press [CLR] for approximately two seconds.
• A beep sounds to confirm that the channel data is
erased.
■ Full Reset
Do Full Reset if you want to erase all data in all
memory channels. Note that this function resets all
settings, that you customized, to the factory defaults,
i.e. menu settings, quick memory, etc.
To do Full Reset, press [A=B]+ POWER ON.