KITCHENAID ARCHITECT KERS206X - Manual (Page 8)

8
Before Setting Surface Controls
About the ceramic glass cooktop
The ceramic cooktop has radiant surface elements located
below the surface of the glass. The design of the ceramic
cooktop outlines the area of the surface element
underneath. Be sure to match the pan size with the
diameter of the element outline on the cooktop and only
flat-bottomed cookware should be used.
The type and size of cookware, the number of surface
elements in use and their settings are all factors that will
affect the amount of heat that will spread to areas beyond
the surface elements. The areas surrounding the elements
may become hot enough to cause burns.
About the radiant surface elements
The element temperature rises gradually and evenly. As
the temperature rises, the element will glow red. To
maintain the selected setting the element will cycle ON
and OFF. The heating element retains enough heat to
provide a uniform and consistent heat during the off cycle.
For efficient cooking, turn OFF the element several
minutes before cooking is complete. This will allow
residual heat to complete the cooking process.
Radiant surface elements may appear to
have cooled after they have been turned off. The glass
surface may still be hot and burns may occur if the glass
surface is touched before it has cooled sufficiently.
Do not place plastic items such as salt and
pepper shakers, spoon holders or plastic wrappings on
top of the range when it is in use. These items could
melt or ignite. Potholders, towels or wooden spoons could
catch fire if placed too close to the surface elements.
Do not allow aluminum foil, empty
glass/porcelain cookware or ANY material that can
melt to make contact with the ceramic cooktop. If
these items melt on the cooktop they may damage the
ceramic cooktop.
Cooktop On and Hot Surface
indicator lights
Your appliance is equipped with two different types of
surface control indicator lights that will glow on the control
panel — the Cooktop On indicator light and the Hot
Surface indicator lights (See Fig. 1).
The Cooktop On indicator light is marked on the control
panel and will glow when a surface element is turned ON.
A quick glance at this indicator light after cooking is an
easy check to be sure ALL surface controls are turned
OFF.
The Hot Surface indicator light is also located on the
control panel and will glow when any surface cooking area
heats up and will remain on until the cooktop has cooled to
a MODERATE level.
Important notes:
• Radiant elements have a limiter that allows the radiant
heating element to cycle ON and OFF, even at the HI
setting. This helps to prevent damage to the ceramic
smoothtop. Cycling at the HI setting is normal and will
occur more often if the cookware is too small for the
radiant element or if the cookware bottom is not flat.
• Be sure to read the detailed instructions for ceramic
glass cooktop maintenance and cleaning in the Care &
Cleaning and Before You Call checklist sections of this
Use & Care Guide.
Fig. 1