KITCHENAID ARCHITECT KERS206X - Manual (Page 7)

7
Cookware material types
The cookware material determines how evenly and quickly
heat is transferred from the surface element to the pan
bottom. The most popular materials available are:
Aluminum - Excellent heat conductor. Some types of food
will cause it to darken (Anodized aluminum cookware
resists staining & pitting). If aluminum pans slide across
the ceramic cooktop, they may leave metal marks which
will resemble scratches. Remove these marks
immediately.
Copper - Excellent heat conductor but discolors easily.
May leave metal marks on ceramic glass (see Aluminum).
Stainless - Slow heat conductor with uneven cooking
results. Is durable, easy to clean and resists staining.
Cast Iron - A slow heat conductor however will retain heat
very well. Cooks evenly once cooking temperature is
reached. Not recommended for use on ceramic cooktops.
Porcelain-enamel on metal - Heating characteristics will
vary depending on base material. Porcelain-enamel
coating must be smooth to avoid scratching ceramic
cooktops.
Glass - Slow heat conductor. Not recommended for
ceramic cooktop surfaces because it may scratch the
glass.
Important note:
Do not place empty aluminum, glass or porcelain-
enamel coated cookware on the ceramic cooktop! The
melting point of cookware made with these materials may
be reached quickly especially if left empty and they may
bond to the ceramic cooktop. If the cookware melts it will
damage the cooktop! Be sure to follow all the cookware
manufacturer’s suggestions when using any type of
cookware on the ceramic cooktop.
Before Setting Surface Controls
Using proper cookware
The size and type of
cookware used will
influence the radiant
element power level
setting needed for
best cooking results.
Be sure to follow the
recommendations
for using proper
cookware as
illustrated in both
Figs. 1 & 2.
Fig. 1
• Flat bottom and straight
sides.
• Tight fitting lids.
• Weight of handle does
not tilt pan. Pan is well
balanced.
• Pan sizes match the
amount of food to be
prepared and the size of
the surface element.
• Made of material that
conducts heat well.
• Easy to clean.
• Always match pot
diameter to element
size.
Fig. 2
• Curved and warped pans.
• Cookware larger than
cooking area marked on
cooktop by more than one-
half inch or 12mm.
• Heavy handle tilts pan.
Check for flatness by rotating a ruler across the bottom of
the cookware (See Fig. 1). Cookware should have flat
bottoms that make good contact with the entire surface
heating element (See Fig. 2). For more detailed
information about the ceramic cooktop see Cooktop
maintenance and Cooktop cleaning in the Care & Cleaning
section.
• Pan is smaller than the
heating area marked on
cooktop.