Kenwood KNA-DV2200 - Manual (Page 32)

30
ENGLISH
Calibration
This function allows you to correct any error in the position or direction of your
vehicle display.
Position Position
Select (Calibration).
Select . Position
2
1
Move the to the correct position and select
. OK
3
Use or to make point in the
direction in which you are driving, and select
. OK
4
(Navigation Set Up) Menu
Vehicle Signal
Select (Vehicle Signal).
1
(Navigation Set Up) Menu
In this screen you can check the navigation connections. The Reverse (REV) and
Speed-pulse (SPD) connections are necessary for accurate calibration and
functionality.
REV. : With the reverse signal wire connected and
with reverse gear selected, the REV indicator
will change to ‘ON’. The current position
cursor will move backwards on the map
screen (whilst the vehicle is reversing).
PKB. : When the handbrake is applied, the destination input is activated.
ILL. :
The illumination connection enables automatic switching of the map screen
between day and night mode.
SPD. : The speed-pulse is received from the vehicle’s electronics and is necessary to
tell the navigation system how fast the car is moving. This speed is an
approximation and may differ from that shown on the vehicle’s speedometer.
GPS : The number of received GPS satellites is shown and the current position,
expressed in Latitude and Longitude.
KNA-DV2200_(E)_ENG_MMC 03.4.8 0:57 PM Page 30