KITCHENAID KSMc50 - Manual (Page 18)

6
optional Stand Mixer Accessories
Mounting Accessory
. Turn mixer off and unplug.
2. Loosen Accessory Knob by turning it
counterclockwise.
3. Remove Accessory Hub Cover.
4. Insert Accessory shaft housing into
Accessory hub, making certain that
Accessory power shaft fits into
square Accessory hub socket. It may
be necessary to rotate Accessory
back and forth. When Accessory is
in proper position, the pin on the
Accessory will fit into the notch on the
hub rim.
5. Tighten Accessory knob by turning
clockwise until Accessory is completely
secured to mixer.
6. Plug mixer in proper electrical outlet
(see page 4).
removing Accessory
. Turn mixer off and unplug.
2. Loosen Accessory Knob by turning it
counterclockwise. Rotate Accessory
slightly back and forth while pulling
out.
3. Replace Accessory Hub Cover.
Tighten Accessory Knob by turning it
clockwise.
General information
KitchenAid
® Accessories are designed to assure long life. The Accessory power shaft
and hub socket are of a square design, to eliminate any possibility of slipping during
the transmission of power to the Accessory. The hub and shaft housing are tapered to
assure a snug fit, even after prolonged use and wear. KitchenAid ® Accessories require no
extra power unit to operate them; the power unit is built in.
®
Accessory hub
Accessory
hub Socket
Accessory
Knob
Notch pin
Accessory Shaft
housing‡
Accessory power
Shaft‡
‡Not part of mixer.
(Accessories not NSf Approved for KSMc50)