Kenwood DPX-7010MD - Manual (Page 8)

Adjust the time.
When the time is not displayed, first press the DISP button to
display the time.
Press the DISP button for at least one second to enter the
clock adjustment mode.
• Adjusting the hours
Press the FM button to advance the hours, or press the AM
button to make the hours go back.
• Adjusting the minutes
Press the ¢ button to advance the minutes, or press the
4 button to make the minutes go back.
Press the DISP button to end the clock adjustment mode. 4
3
2
1
Adjusting Time
General features
— 8 —
English
You can select the display to enjoy sounds with eyes.
Switching the Preset Spectrum Analyzer Display:
Press the COL button for at least one second. "SPEANA CTRL"
is displayed once the Spectrum Analyzer Display Selection
mode is entered.
The spectrum analyzer name currently set appears in the
display.
Each time you press the COL button, the spectrum analyzer
display switches as follows;
Press the COL button for at least one second to end the
Spectrum Analyzer Display Selection mode. 3
▼
▼
▼
▼
▼
▼
▼
"Peak Hold"
▼
"SPEANA scan"
"Loop"
"Radar"
"Champagne"
"Oval Meter"
"Searchlight"
"Side Wave"
The spectrum analyzer display switches in
sequence for 10 secconds each.
2
1
Spectrum Analyzer Display Selection
You can switch the display during the standby mode as
mentioned below.
Switching the Display During the Standby Mode:
Each time you press the DISP button during the standby mode,
the display switches as follows:
Character+Graphic
Clock+Graphic
Clock
Switching Display