Kenwood DPX-7010MD - Manual (Page 34)

— 34 —
English
Troubleshooting Guide
The following messages are displayed when certain problems are occurring in your system. Take the recommended
actions.
Nothing has been recorded on the MD. Blank Disc
No disc magazine has been loaded in the changer. The disc magazine is not completely loaded.
] Load the disc magazine properly.
EJECT
No disc has been loaded in the disc magazine.
] Load a disc into the disc magazine.
The CD is quite dirty. The CD is upside-down. The CD is scratched a lot.
] Clean the CD and load it correctly.
Error-04
No tracks are recorded on the MD, although it has a title. No Track
The protective circuit in the unit activates when the temperature inside the automatic disc changer exceeds 60°C (140°F), stopping
all operation.
] Cool down the unit by opening the windows or turning on the air conditioner. As the temperature falls below 60°C (140°F), the
disc will start playing again.
H-HOLD
No disc has been loaded in the disc magazine.
] Load a disc into the disc magazine.
No Disc
Something is wrong with the disc magazine. Or the unit is malfunctioning for some reason.
] Check the disc magazine. And then press the reset button on the unit. If the "Meca Error" code does not disappear, consult
your nearest service center.
Meca Error
The MD player section is not operating properly.
] Reinsert the MD. If the MD cannot be ejected or the display continues to flash even when the MD has been properly
reinserted, please switch off the power and consult your nearest service center.
The CD player section is not operating properly.
] Reinsert the CD. If the CD cannot be ejected or the display continues to flash even when the MD has been properly reinserted,
please switch off the power and consult your nearest service center.
If the following situations, consult your nearest service center:
• Even though the disc changer is connected, the Disc Changer Mode is not on, with "Aux Mode" showing in the display during the Changer Mode.
• Even though no device (KCA-S210A, CA-C1AX, KDC-CPS85, KDC-CX85, KDC-CPS82 or KDC-CX82) is connected, the AUX Mode is entered when
switching modes.
The unit is malfunctioning for some reason.
Press the reset button on the unit. If the "Error 77" code does not disappear, consult your nearest service center.
]
Error-77
MDs designed for data.
] Please use MDs designed for music.
Error-12