Tuning, Station preset memory, Frequency step setting – Kenwood DPX-7010MD User Manual

Page 11

— 11 —

Store the frequency of a station. You can then recall that
station with a single touch of a button.

Select the band/ station that you want to have stored.

Press the button (#1-6) that you want to use for the station, for
at least two seconds.
The button number blinks once in the display to indicate that
the data has been stored.

Recalling a Preset Station:

Press the preset station button (#1-6) for the desired station.
The number of the recalled station is displayed.

You can store six stations in each of the FM1, FM2, FM3, and
AM bands.

NOTE

Station Preset Memory

Press the SRC (source) button repeatedly to select the tuner
mode. "TUNER" is displayed when the tuner mode has been
selected.

Press either the FM or AM button to select the band.
Each time you press the FM button, the band switches
between the FM1, FM2 and FM3.
Press the AM button to select the AM bands.

• Auto Seek Tuning

Press the

¢ button to seek higher frequencies.

Press the

4 button to seek lower frequencies.

• Manual Tuning

Press the

¢ button to increase the frequency by one step.

Press the

4 button to decrease the frequency by one step.

• Please see the function settings about selecting tuning mode.

(page 25)

• The ST indicator lights up when stereo broadcasts are being

received.

NOTE

Tuning

Switch the frequency step used in seeks. The factory defaults
are 50 kHz for FM and 9 kHz for AM.

Turn the power off.

Hold down buttons #1 and #5, then turn the power back on.
The frequency step settings will be changed to 200 kHz for FM
and 10 kHz for AM.

When you change the frequency step settings, all memory
contents will be erased.

Returning Frequency Step Settings to Original Values:

Repeat steps 1 and 2 above.

NOTE

Frequency Step Setting