Konica Minolta Z20 - Manual (Page 115)

115
The camera temperature rises with extended periods of use. Care should be taken to
avoid burns when handling the camera, batteries, or memory card.
If the camera does not function normally or the system error message appears, turn the
camera off, remove and reinsert the batteries, or unplug and reconnect the AC adapter.
If the camera has become hot with extended use, wait for it to cool before removing or
disconnecting the power supply. Always turn the camera off using the main switch
otherwise the memory card may be damaged and the camera reset.
This manual contains information on products and accessories available at the time of
printing. To obtain compatibility information on products not contained in this manual,
contact a Konica Minolta service facility.
Pictures are
not sharp.
While using
flash, the pic-
tures are too
dark.
Focus signal
is red.
Pictures are
taken indoors
or in low-light
situations with-
out flash.
The subject is beyond the flash range (p.
27, 59).
Subject is too close.
Make sure the subject is within
the autofocus range (p. 24) or
use the macro mode (p. 35).
The camera is in macro
mode. Cancel the macro mode setting
(p. 35).
A special situation is pre-
venting the autofocus
system from focusing (p.
25). Use the focus-lock function to
focus on an object at the same
distance as the subject (p. 24)
or use manual focus (p. 54).
Slow shutter speeds
result in blurred images
when the camera is hand-
held. Use a tripod, change the cam-
era sensitivity to a higher set-
ting (p. 59), or use the flash (p.
26).
Move closer to the subject or
change the camera sensitivity
to a higher setting (p. 59).
DiMAGE_Z20_English_B412.qxd 04.12.27 16:57 Page 115