Before you start, What's in the box, Using the remote control – Kodak DRHD-120 User Manual
Page 5: Putting the batteries in the remote control
Before You Start
5
Before You Start
What's in the box
Thank you for buying this product. Please confirm
that the following accessories are in the box when
you open it.
Using the remote control
Keep in mind the following when using the
remote control :
• Make sure that there are no obstacles between
the remote and the remote sensor on the unit.
• Remote operation may become unreliable if
strong sunlight or fluorescent light is shining on
the unit's remote sensor.
• Remote controllers for different devices can
interfere with each other. Avoid using remotes for
other equipment located close to this unit.
• Replace the batteries when you notice a fall off in
the operating range of the remote.
Accessories
Incorrect use of batteries can result in hazards such
as leakage and bursting. Please observe the following:
• Don't mix new and old batteries together.
• Don't use different kinds of batteries together-although
they may look similar, different batteries may have
different voltages.
• Make sure that the plus and minus ends of each battery
match the indications in the battery compartment.
• Remove batteries from equipment that isn't going to be
used for a month or more.
• When disposing of used batteries, please comply with
governmental regulations or environmental public
instruction’s rules that apply in your country or area.
NOTE
Putting the batteries in the remote
control
1
Open the battery compartment
cover on the back of
the remote control.
2
Insert two AA/R03 batteries into
the battery compartment
following the indications
(+, -) inside the
compartment.
3
Close the cover.
Remote control
AA dry cell batteries x 2
RF cable
Operating instruction
(this manual)
Audio/Video cable
Scart cable