Kenwood VZ907 - Manual (Page 40)

40
English
Installation
5. After fixing parts with double-sided tape, allow it to sit undisturbed
for at least 24 hours. Make sure that no force is applied nor they
get wet during this time.
6. Install the antenna (L&R) by following the steps backward
described in 2.. Make sure that L and R are installed at the correct
side. (Refer to the figure in 2.)
7. Cut the cable holder to the length from the edge of the mounting
bracket to the position where the cable is lead in. Remove the
protective sheet from the double-sided tape on the cable holder
and press firmly on to the rear windshield to fix.
8. Push the antenna cable into the cable holder. Make sure the cable
is not twisted.
9. Route the antenna cable at the side of the gutter of the trunk and
fix few points with the cable clamper. Waterproof bushing should
be fixed on top of the rim rubber of the trunk with the supplied
double-sided tape(Accessory@2) as shown in the diagram.
Clean the place to fix cable clamper thoroughly, as failure to clean
the gutter side wall can not only weaken the adhesive strength of
the double-sided tape, but also cause it to come loose.
10. Route the antenna cable inside the passenger compartment to
the TV tuner and the diversity unit.
CAUTION
• Do not turn on the power of the TV while you are listening to
the radio, especially if the antenna of the radio is printed on
the rear windshield or side windows. There may be
interference in the AM/FM broadcasts of the car stereo.
• Do not use alcohol, benzene, thinner, gasoline or similar
volatile chemical to clean the antenna itself nor cable. They
may damage the product such as transformation,
discoloration etc.
• Remove the antenna from the mounting bracket and keep it
inside the trunk room etc, in such cases like using automatic
car washing machines and when leaving your car for a long
time etc.
CAUTION
Waterproof
bushing
(Accessory@1)
Cable holder
(Accessory!9)
Antenna cable
Cable clamper
(Accessory@0)
Swing angle of this rod
antenna is adjustable
within about 60 degrees.
Flip-up angle can be
selected from 3 positions
with maximum angle of
90 degrees.
The cable can be
routed to the front
side if you remove
the cable from the
hook of the mounting
bracket.
The length of the rod antenna can be
shortened when retracted as it has 8
elements. Use the antenna at full extended
length to obtain specified performance.
The main antenna unit
can be tilted within ± 45
degrees and fix with this
lock screw. The main antenna unit
can be separated from
the mounting bracket
with this release button.
Mounting
bracket
Lock screw
Lock screw