Kenwood VZ907 - Manual (Page 12)

12
English
System Set Up Function
Setting the Minutes to "00":
Touch the [ RESET ] to set the minutes to "00".
Touch the [ RESET ] while the minute is below "30" rounds it off, and
while the minute is "30" or more rounds it up.
Ending Time Adjustment Screen:
Touch the [ RTN ] to return the menu screen.
Adjusting Touch Position
The touch panel can be adjusted if the position touched and the operation
performed do not match.
Switching Touch Panel
Adjustment Screen:
Touch the [ TOUCH ] on the
system setting screen to switch the
touch panel adjustment screen.
Adjusting Touch Position:
Accurately touch the mark at the lower left and the mark at the upper
right, following the instructions in the messages.
When the mark at the upper right is touched, the adjustment is
completed and the system setup screen reappears.
• If [ CANCEL ] is touched without touching the button at the lower left,
the adjustment is canceled and the screen that was set before
switching to the adjustment screen reappears.
• If [ CANCEL ] is touched after touching the button at the lower left,
the button at the lower left reappears.
• If [ RESET ] is touched, the settings are reset to the factory defaults
and the system setting screen reappears.
NOTE
NOTE
Adjusting Time
You can adjust the time manually. Also, with the automatic time adjustment
function set at ON, you can set the clock time automatically according to
time data sent from RDS stations (after receiving RDS signals for several
minutes). The factory default is manual time adjustment.
Switching Time Adjustment Screen:
Touch the [ CLOCK ] on the system setting screen to switch the time
adjustment screen.
Turning Automatic Time Adjustment On/Off:
Touch the [ SYNC ] to switch the automatic time adjustment on
" ON " and off " OFF ".
Adjusting Time Automatically:
Tune to a RDS station and receive the signal for several minutes.
The clock will adjust automatically to the local time.
The clock will not adjust automatically if the RDS station tuned to be
not transmitting time data. In such a case, try another RDS station.
Adjusting Time Manually:
NOTE
SYSTEM
TOUCH
RTN
RDS
1 2 : 0 0
OFF SYNC
RESET
CLOCK
1 2 : 0 0
Touch the [ M ] to
advance the hours.
Touch the [ ? ] to
make the hours go
back.
Touch the [ M ] to
advance the minutes.
Touch the [ ? ] to
make the minutes go
back.
PLEASE TOUCH THE CENTER OF THE BUTTON
IN THE LEFT-BOTTOM CORNER
TOUCH PANEL ADJUSTMENT TOUCH PANEL ADJUSTMENT